How can you skip the bad lighting on the lada priora and change the clutch
Dokato shofirate, vtreshnoto clarification, sort it out, it’s not necessary, but you can’t go to parking without it. In this article, we are talking about Lada Priora cars from Nivat on the equipment “Norma” and “Lux”, we will analyze which lamps for extra lightening are used in tyah and in which light lines are installed.
Containment: 1. How do the interior lighting of the body itself montirani on Priora 2. How to open the capac and change the lampata 3. Possible malfunctions - aco lampata still does not shine 4. Changed to the lampshade "Norm" with "Lux"
Kakvi senki for good lighting with installation on Priora
The car Lada Priora (VAZ 2170) is produced in two fields on the equipment: "Norma" and "Lux". In the first case, a single lamp was used for illuminating the interior on the Priora, located between the kutiyata for the night and the salonnoto looked back at the front. It has a C5W light source with a beche montirana lamp.
Lamp for good lighting Lada Priora
The lamp for wickedly brightening the eye is quite modest and has minimal functionality:
- Vinaghi included.
- Vinaghi is out.
- Turning on this, open some, and even the gates.
Lamp for extra lightening Lada Priora as standard
Lada Priora "Lux" veche and two lamps for extra lighting: front and rear. “Luxury” was extremely illuminating and differed from “Normalnoto” not only in appearance, but also in broader functionality. In addition, the mode “Vinagi is on”, “Disabled” and “Enabled when boiled on the gate”, there are two more:
- Locally clarification on the shofjorskata saddle.
- Locally clarification on a pytnicheska saddle.
These regimens are activated through the separation of the buds, regardless of the other. Predniyat kapak se namira at the place of kato “Norma” - under kutiyata for the eyes. The device is from the use of LEDs and cato from the light source.
Front lamp for extra lightening Lada Priora Configuration required
Backwardly, the clarification of the osiguryava is illuminated on the rear saddle - separately for the left and right side of the pytnik. Include everything independently through a separate butoni. Source for lighting will provide cathodosi on the front - LEDs.
An additional ceiling for lighting on the Priora "Lux" is located above the rear saddle back kjm sdzharzhanieto ↑
How to open the capac and change the lampata
In the tosi, we will analyze how to switch the capaca to the Lada Priora "Norma" lamp and change the lamp. For work, we need a small flat screwdriver and, taking it apart, a new C5W lamp.
Put a screwdriver under the glass from the country to the farmer and I push against it, overcoming the silat on the spring key. Sgvame stalkloto down and remove you from the country for water from the capture from the fener.
Awarded to the glass from the lampat for the extraneous lightening of Lada Priora "Norma"
In front of us is a krushka, fastened from a spring contact. Just go out and put a new one on the ground on the burns.
Smyana on kruskat for terribly lightening Lada Prior «Norma»
What about the repair on the lamp on the Lada Priora "Lux", let's send a tow, so change the LED for it, you need not self-knowledge in radio engineering, but also the ability to keep a soldering iron in the system. If you have this knowledge, you can watch the video for changing the LED in the lamp on the Lux.
Changed to LEDs in the back and back lighting for interior lighting Lada Priora "Lux"
Possible malfunctions - aco lampata still does not shine
Smashed for bad lightening on Priora, for pity, not the only fault. If this happens, when the lamp is working, don’t shine, or don’t keep it short of ochakvaniyata. The root causes for these problems are as follows:
Predpazitel e burned out... Decoction of the installation block in colata - that se namira under the scoreboard left from the water and this brew with a decorative capak with turning all the keys.
The Lada Priora block was installed and numbered on the pre-positioners in it
Preposition F10 with a nominal value of 7.5 A ("Norma") or 10 A ("Lux") is an excuse for lighting on the interior in "Norma" and in "Lux".
Prevklyuchatelyat, enclosed in a lampata, se oxidizing... From time to time (see the previous section), please, contact us cleanly.
Extreme prekshvach in colonata on vratata e is defective... Premahvame is an extreme prekswach, which develops a single self-tapping screw, even with a multiset, set to the mode for measuring resistance. Change the defective edge switch with a new one.
Opened or koso connection kjm tyaloto on the conductor... In the second case, the assumption is constantly izbuhva. Oglezhdama kabelevaneto, tarsim damage, fix it. However, the problem cannot be discovered, if the conductor is excluded from damage, instead of it, it is replaced by a special automobile conductor.
Changed to the lampshade "Norm" with "Lux"
And finally, let’s take a look at how we’ll exchange the standard wicked lighting for the interior on the Lada Priora “Norma” for “Lux”, it’s like a look, it’s meko, it’s not a fountain, it’s meko, it’s shown, in comparison with “Luxozen”, somehow by the view, so and in terms of functionality.
Lightening fener "Norma" (bloatedly) and "Lux" - distinct, somehow se kazva, not obvious
In the first place, it is necessary, yes, but you intend to call often for the nest for the “Lux” fenerche, but not for the “Norm” one, despite the fact that they will.
The nests on the fenerite "Norma" and "Lux" are slightly different in size
Hello! The industry produces Lux nuances from the Norma socket especially for tuning. Those sa are difficult for the namirans, but they exist.
Lux lampshade with box Norma
The novelty is also ideally suited for the computer cable, it is used for wickedly connected to the previous jacket for the phone.
Trouble connecting cable to computer
For yes, yes, it’s using a cable, it’s a ripple and it can be easily modified - yes, pre-break the contact from the fourth contact to the third. Tova e forest and send it with a needle. Squeeze the page retainer and remove the contact from the conductor. Prenarezhdame go in the third - the same shrakne on the meat. Izryazakhme has an additional fourth socket with an ordinary knife. As a result, something similar to the tov received:
Modified connector for socket on fenerceto
Othapvame second connector on the cable, golvame conductor. And so, to the imam, in the ceiling, the plafond from Priora "Lux" ss saves the cable. Might be crushed and pochochne. Broth kutiyata for the preservation of the ochil - cha se namira directly above the ceiling. Use a Phillips screwdriver to develop two self-tapping screws.
Tuk imache self-tapping screw
Develop two more under the fener, which will fix the ogledaloto.
Self-tapping screw behind the eyelid in the cabin
Turn off the connector on the fenerceto, the temperature sensor and dump the capaca together with the fenerceto.
Premahnata tapiceria with deliciously brightening
With the name of the novia connector kjm mestoto on the old one, kato se focusirame vrhu harass down the valley. According to the principle, e sshchoto kato on the old.
Hurry on the contact on the nest on the Lada Priora "Lux"
The author of the editorial staff does not interrupt the old connector, but simply connect the new ones in parallel, so remove the conductor, protect the old one.
The new connector is connected parallel to the old one.
Thank you lampat for the normal lightening on the interior, put "Luxovsky" on the local area. There is no need and change for nothing - somehow in the format, so size it up and clip it, which is imat ednakvi.
Plafont on a new design, replacing the ideal old one
Svarzvame nests on the meat, montirama kapaka and ogledaloto on the meat, fixiram with self-tapping screws.
Noviyat plafond izglezhda much on-hubav, and functionality mu e on-wide.
At the tosy stage, we talk about lightening it on the interior on a car Lada Priora "Norma" and "Lux" can happen. Now we know how you can lampite from different configurations, we can change the tops in ty and if you wish, we can replace the Norma sennik with Lux.
NextTremendously lightening Treacherous lightening on the VAZ 2107 do not shine - how can we change the crowns and which ones are necessary