Correct setting on the sensor for movement for specific tasks
Title: Sensory for movement 
In modern times, many choirs have long been using various devices for energy. Te sa is exactly the same sensory for movement (DD). With the help of help, you can even regulate the inclusion and exclusion of any flock, house, apartment or street itself at the moment when it is necessary. Such a single crush in a lamp or a fener in the yard is not enough and shine too much for a long time.
Containment: 1. Rules for insisting 2. How can the detector be adjusted? 3. Settings 4. Lifeless motion detectors
This device, in a golyamo trsen, does not itself own the private property of the home, but it is such a thing that has spread widely over the control of access and street lamps, lamps on the cemetery. Mogat yes se use and for video surveillance. In an extreme estimate, it is not the most conveniently light and shine without much effort, when a person appears at a certain place. Osvent's wealth of energy and, as a result, personal finances. But if you try yourself and install such equipment for the first time, then it will be more useful and teach you how to set up the motion sensor.
First try carefully and read the instructions. You will check if the equipment was given the answer to the document in the passport for the equipment. Working on this device is very simple. The sensor for the movement is constantly observing the flock or around with the help of the infrared light. Once the object is moving, giving a signal (depending on the setting) and making contact, it will turn on according to the verigata, as a result, some electricity will be supplied to the lighting rod, spotlight or lamp.The trace is known to the time, with the lipsa on repeating the signals, the verigata is the prekvasva and the light is the exception.
Schemes on the connection to the sensor for movement
The circuit diagram for the connection of the trap is shown in the instruction manual attached to the device. Depending on the model on the sensor for the movement, it is carried out in two ways - from the transition to the neutral conductor or the direct connection to the illuminating body. In this case, the conductor of the vinagi ima prekshvane is in contact with the samiya sensor. This is for sure, before you bend the electric chain, try carefully and read all the dots, the descriptions in the instructions, and configure the device correctly.
Ima two kinds of sensori per move:
- Active.
- Passive.
Turn on the microwave and ultrasonic DD. Tyakhnata work and watch constantly the premises. Whenever they receive sounds and sounds, contact them and they will engage and bright light. Ultrasound is a little more popular, while constantly moving on a moving object, it emits waves, which, with a long exposure, can and will give weak indications at the top of the body.
Microwave ima golam plus, for the difference from ultrasonic, maybe even trsi prez obstacles under the format on the wall. For the sake of Comrade, I have crawled into sorzheniya for sighurnost. Km it can be yes, all pumps and a camera, for yes, a video recording at the exact moment. But this is not a bad thing, because the probability of a false reaction is increasing.
An infrared sensor for the movement of all its operations, when it appears to be fuel-efficient. Thy kato chovek or animal imat determined bodily temperature, those, in response, expel infrachervena light. When the sensor opens so the signal, contact it will close and lightening it will turn on.They can be both passive and active.
How to work IR motion sensor
In the first case (passive), keep a constant eye on the temperature for the surrounding environment. Vvv second (active) - the receiver and transmitter for the signal from the installation are separately one from the other. And once the signal is interrupted between the ties, then the contact will turn on and the lamp will turn on. Acoustic DD is passive. They will use them from dancing, talking, all kinds of noise, some of them appearing in the zone for them to act.
It is possible and all because of such a name is a mixed type, there are some active and passive elements. False reaction to such a species sensory is reduced to a minimum. Therefore, they are valued from order to temple.
Rules for insisting
For the most efficient use and maximum savings on electricity, DD trebva and all installations in place, for some reason ima nay-golyamo movement to the chorus and golems of pets. Tova lo rule not by itself closed, but also openly, for example, in the yard with a view of your own.
From the view of the sensorite installation:
- Tavan.
- Montirand on the wall.
The principle of action on all things from tyah is not a change from tov. Vsichko depends on local conditions. But contrary to Tova, the tavant has crawled more and more into little flocks. It is preferable to install it on a height from 2.5 to 3 meters. According to the tosi, the sensory beginnings are even more likely to cover an area with a diameter of 10–20 meters.
Stennitize the sensory, and use it both closed and open. Accordingly, they are widely used in electrical networks for external clarification. Vysochinata on the installation on the takiva DD in the room is slightly lower from the tazi to the tavana and up to 2–2.5 meters. Understanding this, you can install the stenny sensory everywhere, but the experts will spoil it and send it to the flock.Tova dava in the naked is visual ygl. Ako installation of this perverse street, togava tryabva and I soak in the sap for a clear movement to the choir.
On the street, nivoto on the installation can reach 10 meters. Sensor self-mounting at an angle from approximately 40 degrees directly horizontal to the surface to effectively track the zonate. The working range is individual for each model. But tryabva and this ima foresee that when you golyamo dissipate on the falsehood, increase it on an excuse.
Preferentially put on DD back kjm sdzharzhanieto ↑
How can the detector be adjusted?
All the time sensors for the movement and the regulator for setting the parameter on the reaction. Those are necessary for the correct operation, such that the device is performing its functions in full. With the help of tyahna, you can adjust the sensitivity, illumination, and time for fun during shutdown. Installation yagl se regulated mechanically.
In the case that you use the old DD model, it is possible that you control only two parameters - the time on the fun and the sensitivity. You can trace the tov and you can separate the sensor for light.
Settings
If you set all the parameters correctly, then the cost of electricity can reach 50 percent. This is a significant figure when comparing energy tariffs. As a rule, three regulators are installed on new sensory models per movement - LUX (DAY SVETLINA), TIME, SENS.
LUX is not an excuse for adjusting for lightness, TIME is for fun on the switch, SENS is for adjusting the sensitivity to the reaction.
Ygl for installation
When installed on a DD, it is closed, as a rule, by putting a dot in the gula in the nai-visokata.By the way, at first it is possible to find the correct location in relation to the area, but still the traffic is intensive.
For example, a sensor is installed in the corridor, you can get close at the same time from a few flocks or a kitchen, then it’s soaked in a sock, in some way you can cover the maximum territory. So, every time an object appeared from someone and even a passage, the system for warning of its involvement through the zatvoryan on mrezhata. Vneshnoto location and visochinata for installation can yes variat. But it’s not necessary, but watch out for darvetata or other objects, for which the reaction to the sensor is not desirable, but don’t fall into flight on the action on infrachervenite lchi.
Basic settings
Naturally, ima and mertvi zone, somehow lie not all the cracks and the sensor can’t react. But with the correct installation, they themselves are minimal and do not affect the work on the device.
Sensitivity
For yes, DD yes, for the preference of the chorus itself, above all, yes, set the regulator with the inscription SENS to medium value, that is, between plus and minus. If it is set incorrectly, turn on the lighter when moving to small objects. If you wish, the range can be divided into several sectors of 45 degrees. Tova szdava zone, kadeto otkrivaneto e for sure. Each section of the ima is a special delimiter.
Lightening
Tosi parameter is adjustable with LUX control. If you use the sensor unnecessarily, stop the clock from changing the position and setting to the maximum. Such a pragmat on the zatvaryan on the contact is in the dark, sometimes on the night or a flock without insight. In a higher price category, Ima DD with a time setting on the fun when you turn it off. But if you don't look for it and don't, then you can install an additional photo of the relay.
Refinement
The range for response when excluded is only given on an individual request. Regular trading period from 1 second to 10 minutes. In the expert report, the time is estimated at 50-60 seconds.
By the time the motion sensor is activated, the motion sensor is more responsive, and consequently it is also excluded for a long time, which is also set in the settings. But the next step, once the timer is activated, then work in the correct mode, just set up.
Boutoni for setting up a tyaloto on a sensor back kjm sdzharzhanieto ↑
Lifeless motion detectors
For autonomous work without connection to the electric network, you will use the lifeless DD. They can and do protect from the solar panel, battery or battery. The term for exploitation without pre-warning is from 6 to 12 months. Depending on the price category, different settings are possible.
Such a che evtinite lifeless models ce installirat itself on closed. Ty kato imat is weakly power on the protection of the cross-section of the factory. Nyama detector for immunity to pets. The girth on the betrayal on the signal is up to 100 meters.
But copy a copy of the montirat not only closed, but also open. They work under all kinds of climatic conditions. Unfavorable meteorological conditions such as rain, snow, or bright sunshine will not affect the work of the sensor in any way. Ima and setting for ignoring on objects with teglo up to 40 kilograms (pets). Osventova can and cezpolzva mixed regime for work.
Ima models curtain type. Those traceable is clearly limited area. Often, they crawl close to the vrata or insight, for yes, prevent it from neotorizirano vlizane on neotorizirani faces in flocks.
The principle of action is to transmit a radio signal with the frequency of the receiver determined.Thanks to the protection of the radio signal, the possibility of embarrassment is excluded in other respects. Ako ima visible line between the unit for control and sensor for movement, then the distance for betrayal on the signal can be up to 500 meters.
Lifeless motion sensor
Alarm block ima vgraden GSM module ss SIM card. Whenever DD is activated, when the device sends a signal, the trace is sent to the phone by sending an SMS message, someone's number is previously entered in the memory of the device. By tosi beginnings, you can secure every flock or, for example, a garage, located far from home.
Generalizations, ima nakolko rules, spasvayki koito yes configurate Direct si yourself sensor for movement more forest and simple:
- Remove as much as possible more of the lights of the body, which can and will affect the correct work on DD.
- Do not place nearby heaters, including air conditioners. Thy kato vsichki sensori for the movement sa sensitolni to the movement to inhale pototsi.
- Install the device in such a way that in no way can objects be interrupted at a glance. According to Tosi, the area for the device has begun to be worked on, and it can be increased.