How do lampi se use a ford focus 2 and how do you change

A failure on the lamp in the lighting device for cars can be a nay-chesta malfunction. In the article, we will analyze how to independently change the brakes of the Ford Focus 2.

containment: 1. Regarding the second generation of the Focus 2. Type of use of the crumb 3. How can we change the caps in the farovet 4. Smyana on krushkat on farovet for mist 5. Maintenance on the rear lights 6. How can we change the numbers to pins 7. Change the pin for the backlight on the scoreboard 8. Vtreshno clarification 9. Ami ako the trace of the crumpled lampata still does not shine?

Relatively second generation Focus

Published for the second generation on the Ford Focus car, starting in 2004 and continuing until 2011. Four years after the start (prez 2008), the manufacturers make a perverted restyling, which can’t be called zadlbochen: it’s self-relief on capaca, arcite on colelata, armor, looked around the change easily, added a spoiler and other drebolia.

Ford Focus 2 pre-facelift (2004-2007)Ford Focus 2 trace restyling (2008-2011)

The revisionist is zasegna and farovete. Those received an aggressive form, but it is important that the design was changed to fener. Ako in Focus 2, before restyling, light up for long and kasi light lines byah location in a single common hatch, then a trace of the revision of every krushka get your own.

Pre-styling headlights on the Ford Focus 2 (very) and post-styling

As far as the format for the car series is concerned, the Ford Focus 2 in this respect has no modifications: hatchback with three gates, hatchback with five gates, convertible, sedan and combi.

back kjm sdzharzhanieto ↑

Type of use of the crumb

Let's go ahead and let's go ahead, let's break it down, we'll analyze some of which lamps are used on the Ford Focus 2. In an extreme estimate, go ahead and change it, tryabva and buy it, you need it for something. Such a manufacturer of installation, follow the type of lamp in your cars before and after restyling.

Exterior view of the car, crawling in a Ford Focus 2

In the picture, the numbers show:

• 1 - kasi light. Halogen, base H7, power 55 W;
• 2 - long light. Halogen, base H1, power 55 W;
• 3 - Farove for mist. Halogen, base H11, power 55 W;
• 4 - lightening on the registration number (sedan), bright lightening (dorestyle). Lamp with push button type C5W, power 5 W;
• 5 - repeater on the back. Lamp with push button and orange cap, type W5W, power 5 W;
• 6 - lightening on the registration number, gibkat, trunk, interior, show the light line for the parker. Lamp with push button type W5W, power 5 W;
• 7 - helical lightline / rear lightline behind parkier. Double-wound reel with red cap type P21 / 5W, power 21 and 5 W;
• 8 - pate indicators. With push button with orange cylinder, type PY21W, power 21 W;
• 9 - return signal. Push button type PY21W, power 21 W;
• 10 - taillight for mist, rear lights for parkirane. Double winding with pressable trap type P21 / 5W, power 21 and 5 W.

back kjm sdzharzhanieto ↑

How can we change the crashes in the farovete

In the headlight on the Ford Focus 2, you have a lamp, answer for the long light line, check the light line, page the light line and show the indicator.

Somehow veche razbrahme, lamp for long distances and kasi light line sa location in one and eat the hatch (dorestyling) or each in a separate one. Crush with the dimensions and indicators of the same ny-malkite, and in two versions for cars, those are installed in a separate socket on the replaceable sockets.

The lamp itself is the headlight of the Ford Focus 2 sa thinning in the last edition: close to the center of the car, the imprint of the indicator, the next device for the length of the light line, followed from the light line and in the samata country-lamp on the size.

For yes, change any of the crashes, and if necessary, dismantle the headlight - develop the fixing screw and squeeze out the two keys. Next, open the hatch of desire and change the burning lighting device (far, near) or turn the cartridge back on the clock hand and take it out of the junk (dimensions, indicators). Leave it alone and leave the burnt knuckle and yes I will replace it with a job.

Smyana on krushkat for the long lightSmyana for krushkat for kasi svetliniChange on the indicatorCrushed into a page crush

You can read it more for dismantling on the headlight and crushing it on the lamp in the statue “How do you need a light line on a Ford Focus 2 and how do you change it”.

back kjm sdzharzhanieto ↑

Smyana on krushkat on farovet for mist

Crushed on the headlights for the mist for the Ford Focus 2 yama and even difficult. Tova shche iziskva:

• flat screwdriver;
• a set of keys Torx;
• clean pamuchni rakavitsi;
• backup lamp with base H11.

On the first place, the premahvam is molded, which is from the bottom and the onslaught of the key, the location is removed and burnt out with a screwdriver.

Premahnatiyat layst, see all places for rezeta

Sega premahwame cladding on farowet. To the e is attached with the keys.

Premahvane on the lining on the farovet for the mist

The veche imam has access to the headlight beyond the darkness. Premahvam go, by developing two screws, the location is removed from the Torx wrench.

Important! Tryabva and se will loosen up the screw itself. Screw, located on the edge with a small slot, e adjusting the screw!

Remove the headlight, getting access to the decompressor, put in the lamp. Squeeze two pinches and skip the block. I’ve got the headlight, I’ve got the lamp back on the watch arrow, I’ve got it from the nest. Install nova on the locality, let’s add a trace of kato rkavitsi, ty kato halogen lamp can’t be here with goli ryatse. Correct the headlight, zakopchavame facing and molded.

When restyling the model, you can reach the headlight behind the foggy front of the engine compartment. For yes, send Comrade, it’s enough for him to pass the headlight (described in a mountain).

back kjm sdzharzhanieto ↑

Maintenance on the rear lights

In the back of light on the Ford Focus 2, there is a spiral / page of light (two-vein), a pate indicator, an indicator for the rear. Remove those positions in the following sequence, which are further from the center on the car:

• spiral signal (spiral light);
• reverse;
• flasher;
• page light / back light for darkness.

Important! In the modification to the Ford Focus 2 sedan, the manufacturer attaches separately mugs P21Wdissuaded for a page light and for a spiral signal.

The lights of the lampis are one and the same basis, and they can fall down one at a time and eat the beginnings - turn them back on the watch hand. When a car is a sedan, the rear seer (otgor) is an additional spiral light, in some cases there is no miniature W5W muffler.

How to open up the main and additional light lines and reach to the lamp, you can read it in the article “How can we change the coil for a spiral lamp on a Ford Focus 2”.

back kjm sdzharzhanieto ↑

How can we change the numbers to pins

Let's remember some modifications, which use the C5W lamp for lighting on the registration number. Imam two light lines, located in the back gate.Those are fixed with two self-tapping screws. Twist the screw with a Phillips screwdriver. I use a fener with a slotted screwdriver, and I use a slotted screwdriver, and I need to protect the conductor from a sufficient supply.

Premahvane on the lampata on the registration number

The lamp is open with a frame, which I will skip, we will get access to the krushkat. Izvadame burned out, put a new one.

Izvadane on the crash

If it’s necessary to skip the whole fener, unplug it, put a conductor on the guard, it’s just a waste.

Exclusion on the protection of the conductors from the backlight on the registration number on the Ford Focus

We’ll change the kato’s track, put the fener on the meat and fix it with a self-tapping screw.

Premahvane on the lampata on the registration number

And now for the modification, which is from the W5W crash cover (see the section “Types of crash cover use”). The light on the registration number is not mounted at the top of the self-tapping screw, but at the top of the spring cut, located away, something close to the center of the car. You can even use a flathead screwdriver, but it's more convenient to use a small Torx wrench.

We’ll get rid of the cato’s trace of the fenerceto, we can still see the patron.

Premium lamp for registration number

Zavartame go back to the watchman’s hand and go out of the way with a crusher.

Dumped a nest with a battered krush

Izvezhdame burned out the device and installed a new one.

back kjm sdzharzhanieto ↑

Change the pin from the backlight to the scoreboard

We’ll solve some vednaga - there are no crashes in the Ford Focus 2 on the reinforcement scoreboard. Answering for not ready lighting and indication SMD LED 5630... They will spend a lot of time from lamps from a lit zhichka, but they can do something like that and they will hurt it.

So everything else happened, togava dismantling the reinforcing panel, which is pre-premahnahme decorative visor.

Premahnato scoreboard for driving Ford Focus 2

Now premahvame arrows, kato gi zavartame according to the hour hand and gi darpame kam se si.

Pre-machine on arrows

Open the panel, squeeze the key and mahame duskata.

Premahvane na dskata

From the other side of the country, a few dozens of LEDs are on the edge of the curve, the unit from which is indicated with a marker.

LEDs from the foreign country on a scarf

Vorzhavame with a soldering iron and replace it with a new one, or simply with a knowledge of an electronics engineer.

back kjm sdzharzhanieto ↑

Vtreshno clarification

For extra lightening on the Ford Focus 2 and 3 covers, arranged in a single ceiling and all included from a separate button. At the same time, dorestyling crawl 2 lamp W5W and one C5W, restyling - 3 lamps W5W.

For yes, change the caps, and if necessary, move the protective glass onto the ceiling. Carefully squeeze the one away and pull it out to yourself, until the keys are separated from the pinch on the fener.

Premahvane on the protective glass for extraneous clarificationInterior lampi

Before us ima three krushka.

Premahwame gi, kato just gi from time to time and change. Montirame protectively glassed on the meat.

Important! The picture shows the pre-styling lamp Ford Focus 2. In the restyled modification, we correct everything from the beginning, just install the lamp and the W5W lamp in the center.

back kjm sdzharzhanieto ↑

Ami ako is the trace of the lampata crushed still not brighter?

The case is that the trace is crushed on the crusher, fenert or fart still does not revive. How can it be a problem? Nai-Cheso meeting e burned out the prepasitel.Namirame montage block: toy se namira in the compartment under the frog. Fasten the fixing screw, screw the block back.

Premahvane on mounting block

Ako colata is pre-formed, then the assembly of the block is as follows:

Mounted block Ford Focus 2 "dorestyling"

The purpose is on the prepositional, dissuade for clarification, and somehow following (number sa put close to the prepositional on the hulls on the ward):

• F37 (10 A) - long light lines on the headlights;
• F38 (10 A) - long light lines on the gums of the headlights;
• F45 (10 A) - page light (total);
• F47 (10 A) - reinforcement panel;
• F48 (20 A) - and two headlights of the light line (general);
• F49 (15 A) - main switch for the lighting device;
• F53 (7.5 A) - page light, spiral light port;
• F54 (17.5A) - page bright, stop gums;
• F60 (15 A) - lyav headlights kasi svetlini;
• F61 (15 A) - gums headlights of light;
• F73 (7.5 A) - lighting on the registration number;
• F84 (15 A) - light lines for rear travel.

Ako imame "restyling" on the Ford Focus 2, togawa mount the block from the following way:

Ford Focus 2 block "restyling" installed

Celta on the prepastelite follows:

• F103 (10 A) - save on the system for control of external lighting;
• F104 (10 A) - wicked brightening;
• F110 (10 A) - key for external clarification;
• F113 (10 A) - page light lines (general);
• F116 (20 A) - headlight for mist (PTF);
• F117 (7.5A) - clarification on the registration number;
• F125 (7.5 A) - pages of light lines, gums stop light lines;
• F132 (15 A) - common light spirals;
• F139 (10 A) - long light lines on the headlights;
• F140 (10 A) - long light lines on the headlights;
• F142 (15 A) - headlight gums for light lines;
• F143 (15 A) - beam of headlights behind the light line.

The other reason is crossed, it is oxidized or burnt out on a connecting block or on a lampite. The picture below shows that the light on the registration number does not work for the sake of the fire on the contact on the cassette.

Izgarians on contact on djrzhach on lampata

Let's replace the lamp with the Ford Focus 2 from any modification. Now you can do it yourself and do it with lighting the bodies on colata si.

PredishnaChange on automatic lamps Protect the size on the VAZ 2110 they don’t shine and how can you change the cover in tyNextChange on car lamps